Sealmaster® 714279 MORNPL20XLO

Sealmaster® gold mounted ball bearings feature a wide outer race insert bearing with land riding metallic retainer. The black oxide treated bearing steel insert features an exclusive lock pin and dimple system providing a direct path for lubrication into the bearing, and prevents outer ring rotation within the housing. Shaft lock is achieved by either setscrew or Skwezloc® concentric locking collar. The felt seal with flinger provide a good balance between contaminant entry, GoldPlex® HP grease loss and friction. Depending on your preference, these bearings are available in both inch and metric shaft sizes with a wide variety of cast iron, stamped steel or rubber mount housings, sealing, and lubrication options or industry specific solutions.

Sealmaster® Pillow Block Ball Bearing Unit, Standard-Duty, Series: NPL, 1-1/4 in Bore, 4-11/16 to 5-5/16 in Bolt Center-to-Center Length, 1-13/16 in Base to Bore Centerline, 6-9/16 in Overall Length, 1-11/16 in Overall Width, 3-11/16 in Overall Height, Two-Bolt Base Mounting, Round Bore, 1-7/8 in Base Width, Set Screw Locking Device, Cut Down Oil Soaked Felt Seal, Non-Expansion (Fixed) Expansion, 5782 lb Dynamic Load, -20 to 100 deg F, 1850 rpm Maximum, Cast Iron

• Wide outer ring
• Lock pin and dimple
• Zone hardened inner race
• Land riding retainer
• Housing fit
• Metal nameplate riveted to the housing allows for easy identification even after years of operation
• Extra low drag
• Oil grease
• Alemite fitting lubrication
• 52100 black oxide coated steel insert

• Specification Sheet https://externalassets.unilogcorp.com/ASSETS/DOCUMENTS/ITEMS/EN/Sealmaster_700566_Specification_Sheet.pdf