Morse® 172704 MORB207A

The B200/B500 series clutches share the same design. A full complement of cams is retained in an outer race. This requires a bearing supported hardened shaft as the inner race. These are primarily used for back stopping applications. It can also be used for indexing and overrunning applications as well. The B200 series has the same outside diameter as a metric 200 series ball bearing. This makes it easy to facilitate assembly adjacent to the ball bearing. The B500 series was created as a replacement backstop for many different gear reducers. It comes in many different diameters and generally has a larger cam than the B200 series clutch. Both series come pre-lubricated with special light grease. In service they can be lubricated with either grease or oil.

Morse® Mechanical CAM Clutch, Series: B200, 1.656/1.657 in Bore, 2.8326/2.8341 in OD, 1-1/8 in Overall Length, 275 ft-lb Torque, 2000 rpm Overrunning Maximum, Shaft Mounting, 1-1/8 in W Dimensions

• Clutches require bearing support to assure concentricity between inner and outer races
• Rugged cam clutch designed for applications where space and weight are factors in clutch selection
• Input shaft used as the inner race must be hardened and ground to size
• Interchangeable with competitors product
• Lubrication required
• Taper on this shaft should not exceed .0002 in per inch
• Morse and Browning offer a complete line of Torque Overload Devices to protect machinery from overloads or jams
• Replacement springs are readily available at 1 per pack

• Specification Sheet https://externalassets.unilogcorp.com/ASSETS/DOCUMENTS/ITEMS/EN/Morse_172701_Specification_Sheet.pdf