Koyo IR-1016-OH KOYIR1016-OH

Where it becomes impractical to meet the shaft raceway design requirements (hardness, case depth, surface finish, etc.) outlined in the engineering section, standard inner rings for drawn cup bearings are available. Inner rings for drawn cup bearings are designed to be a loose transition fit on the shaft and should be clamped against a shoulder. If a tight transition fit must be used to keep the inner ring from rotating relative to the shaft, the inner ring OD as mounted, must not exceed the raceway diameters required by the drawn cup bearing for the particular application.

Koyo Inner Ring, Regular Width, Series: IR Inch Series, 5/8 in ID, 7/8 in OD, 1.015 in Overall Width, For Use With: B-1416, BH-1416, J-1416, JH-1416, M-14161, MJ-14161, MJH-14161 Drawn Cup Needle Roller Bearing, Oil Lubrication Hole, Steel, Polished Chrome

• Ideal choice when shaft is not practical to use as inner raceway
• Designed to meet established inch tolerances
• Designed to be wider than matching drawn cup bearing
• Maximum shaft fillet radius cannot exceed inner ring bore chamfer
• Designed to provide a loose transition fit on the shaft and should be axially clamped against a shoulder
• If a tight transition fit must be used to keep the inner ring from rotating relative to the shaft, the inner ring OD must not exceed the raceway diameter for the matching drawn cup bearing after being mounted on the shaft
• After mounting, if OD of inner ring exceeds the required raceway diameter for matching bearing, ring should be ground to proper diameter while mounted to shaft

• Catalog https://externalassets.unilogcorp.com/ASSETS/DOCUMENTS/ITEMS/EN/Koyo_NATR10DZ_Catalog.pdf
• Catalog https://externalassets.unilogcorp.com/ASSETS/DOCUMENTS/ITEMS/EN/Koyo_NATR10DZ_Catalog.pdf