IPTCI Bearings UCFL210-50MM IPTUCFL210-50MM

UCFL Series Standard Duty 2-Bolt Flange ball bearing unit features a cast iron housing and a ball bearing insert with flinger seals and set screw lock. The housing is made of cast iron for rigidity and vibration dampening, and has a solid base for mounting stability. The double-sealed, deep-groove ball bearing insert is made of through-hardened chromium steel and is appropriate for applications with moderate radial loads and light thrust or combination loads. It has a wide inner ring on both sides for increased shaft support and reduced inner-ring tilt for smooth operation. The insert bearing has a sphered outer surface that allows it to self-align within the housing & compensate for misalignments. It also has an anti-rotation pin in outer surface that prevents the bearings from spinning within the housing and ensures smooth performance. Steel-reinforced molded rubber lip seals with flingers on both sides of the bearing retain the high quality multi-purpose lubricant and deflect contaminants away from the seals. ~~ The bearing locks onto the shaft with two set screws spaced 120 degrees apart for a three-point contact hold. Set screw locking is suitable for low to moderate speed applications where the shaft rotates in a single or reversing direction. The unit is equipped with a grease fitting on the housing’s outer surface for reapplying lubricant, and the insert bearing has a groove and oil hole in the outer ring to efficiently channel grease into the bearing during re-lubrication. ~~ Ball Bearing Pillow Block units are suitable for use in industrial and commercial applications including industrial machinery, conveyors, fans/blowers, agricultural equipment, construction machinery, exercise equipment, and food processing equipment, among many others.

IPTCI Bearings Ball Bearing, Normal Duty, Series: Silver UCFL 200, 50 mm Bore, 157 mm Bolt Center-to-Center Length, 2-Bolt Flange Mounting, 197 mm Overall Length/Diameter, 54.6 mm Overall Depth, 115 mm Overall Height, Set Screw Locking Device, Cast Iron Bearing, 35000 N Dynamic/22830 N Static Load, 3400 rpm Maximum, 10 to 200 deg F

• Wide Inner Ring Bearing
• Dual Seals (B-Type)
• Pre-Lubricated with quality NLGI2 Bearing Grease
• Relubricatable through included Grease Zerk

• Catalog https://externalassets.unilogcorp.com/ASSETS/DOCUMENTS/ITEMS/EN/PTI_03B100A_Catalog.pdf
• Instruction/Installation Manual https://externalassets.unilogcorp.com/ASSETS/DOCUMENTS/ITEMS/EN/PTI_CLFL20412_Manual.pdf
• Specification Sheet https://externalassets.unilogcorp.com/ASSETS/DOCUMENTS/ITEMS/EN/PTI_CLFL20412_Specification_Sheet.pdf
• VIDEO LINK https://www.youtube.com/watch?v=pWhSAr3Ii1A