IPTCI Bearings SUCTF208-24L3 SUCTF Standard Duty Flange Ball Bearing, 1.5 in Dia Bore, 102 mm L Bolt Center-to-Center, 4-Bolt Flange Mount, 130 mm OAL/Dia
SUCTF Standard Duty 4-Bolt Flange ball bearing unit features a Thermoplastic housing and a Stainless-Steel ball bearing insert with flinger seals and set screw lock. The housing is made of reinforced PBT that provides low water absorption and excellent dimensional stability provide superior resistance to chemical attack. . The housing has a solid base for mounting stability, and to eliminate crevices that act as entrapment points in wash-down applications. ~~ The Triple-Lip Sealed , deep-groove ball bearing insert is made of 440 grade Stainless and is appropriate for applications with moderate radial loads and light thrust or combination loads. It has a wide inner ring on both sides for increased shaft support and reduced inner-ring tilt for smooth operation. The insert bearing has a sphered outer surface that allows it to self-align within the housing & compensate for misalignments. It also has an anti-rotation pin on the outer surface that prevents the bearings from spinning within the housing and ensures smooth performance. 300 Series Stainless Steel-reinforced molded rubber lip seals with flingers on both sides of the bearing retain the high-quality Food Grade multi-purpose lubricant and deflect contaminants away from the seals. ~~ The bearing locks onto the shaft with two set screws spaced 120 degrees apart for a three-point contact hold. Set screw locking is suitable for low to moderate speed applications where the shaft rotates in a single or reversing direction. The unit is equipped with a grease fitting on the housing’s outer surface for reapplying lubricant, and the insert bearing has a groove and oil hole in the outer ring to efficiently channel grease into the bearing during re-lubrication. ~~ Thermoplastic / Stainless Steel Ball Bearing Pillow Block units are suitable for use in industrial and commercial applications that require corrosion resistance due to frequent wash-downs or are operating in a caustic environments such as food processing equipment and machinery, and pharmaceutical producing / processing equipment, among many others.
IPTCI Bearings, SUCTF208-24L3, Flange Ball Bearing, Standard Duty, Series: SUCTF, 1.5 in Bore, 102 mm Bolt Center-to-Center Length, 4-Bolt Flange Mounting, 130 mm Overall Length/Diameter, 53 mm Overall Depth, 130 mm Overall Height, Set Screw Locking Device, Thermoplastic Bearing, NBR Seal, 5660 lb Dynamic/3300 lb Static Load, 250 deg F
| Bearing Material | : | Thermoplastic |
| Bolt Center-to-Center Length | : | 102 mm |
| Bore Diameter | : | 1-1/2 in |
| Flange Mounting Type | : | 4-Bolt |
| Load Capacity | : | 5660 lb Dynamic/3300 lb Static |
| Locking Device | : | Set Screw |
| Overall Depth | : | 53 mm |
| Overall Height | : | 130 mm |
| Overall Length/Diameter | : | 130 mm |
| Seal Material | : | NBR |
| Series | : | SUCTF |
| Temperature Rating | : | 250 deg F |
| Type | : | Standard Duty |