IDC Select® IDC GEH 35ES 2RS IDCGEH35ES-2RS

Spherical plain bearings are manufactured in a wide variety of materials to offer bearing solutions in almost any operating environment. IDC Select® bearings offer a line of spherical bearings in inch and metric. They utilize inner and outer rings with spherical sliding surfaces and can accommodate heavy radial loads and bidirectional axial loads at the same time. The variety of designs offer misalignment, angular contact, an extended inner ring, case carburized and enhanced lubrication groove spherical bearing designs. These products are used in pivoting, high load bearing applications where angular misalignment is required. Most typically, spherical plain bearings are employed in hydraulic cylinder rod ends, vehicle steering linkage suspensions, heavy equipment articulated joints and other severe duty uses.

IDC Select® Spherical Plain Bearing, Heavy Duty, Series: GEH, 35 mm Bore, 62 mm OD, 35 mm Width, Double Seal Closure, 495 kN Load, Steel Bearing, Rubber Seal

• For heavy radial and bidirectional axial (thrust) loads at the same time
• Wide inner ring and large OD capable of greater misalignment
• Sliding surface steel on steel MoS2 treated
• Single fracture design
• Relubricatable through annular grooves and oil holes in inner and outer rings
• 99 kN dynamic/495 kN static load capacity

• Technical Bulletin https://externalassets.unilogcorp.com/ASSETS/DOCUMENTS/ITEMS/EN/IDC_SELECT_IDC_CB2107_Technical_Bulletin.pdf