FAG NJ2318-E-XL-M1-C3 FAGNJ2318EXLM1C3

Bearings of type NJ have two rigid ribs on the outer ring and one rigid rib on the inner ring. With these cylindrical roller bearings, axial displacements of the shaft relative to the housing are possible in one direction only. The maximum axial displacement s is given in the product tables. Bearings of type NJ are used as semi-locating bearings, i.e. they can guide the shaft axially in one direction. Semi-locating bearings NJ can be combined with an L-section ring HJ to form a locating bearing unit.

FAG Cylindrical Roller Bearing, Separable, Series: NJ23-E, 90 mm Bore, 190 mm OD, 1 Rows, 64 mm Width, 530000 N Load, Solid Brass Cage, 4250 rpm Maximum, -30 to 150 deg C

• Bearing arrangements are subjected to very high radial loads
• Not only high radial forces but also axial loads from one or both directions must be supported by the bearing position
• Bearing arrangements must have very high rigidity
• Axial displacements of the shaft relative to the housing must be compensated without constraint in the bearing
• High radial loads and very high speeds occur but the very high radial load carrying capacity of full complement cylindrical roller bearings is not required
• Semi-locating bearing function
• Increased capacity design
• X-life design
• Solid brass cage, two-piece, roller-guided
• C3 radial internal clearance
• 510000 N dynamic/530000 N static