Browning® 767297 BROVPLE114

Browning® mounted ball bearings feature multiple housing styles, materials and configurations, an extended inner race insert bearing with ball riding nylon retainer. The insert features a rivet to prevent outer ring rotation and is available with setscrew, eccentric, or BOA concentric locking collar. The contact seal, with black oxide treated flinger provides a good balance between contaminant resistance, grease loss and friction. Depending on your preference, these bearings are available in inch and metric bore with a wide variety of cast iron, stamped steel or rubber mount housings or specific industry solutions as illustrated on the pages to follow.

Browning® Pillow Block Ball Bearing, Intermediate Duty, Series: VPLE 100, 7/8 in Bore, 3-23/32 to 4-17/32 in Bolt Center-to-Center Length, 1-5/16 in Base to Bore Centerline, 5-1/2 in Overall Length, 2-11/16 in Overall Height, Two-Bolt Base Mounting, Round Bore, 1-13/32 in Base Width, Eccentric Locking Device, Single Lip Seal, Non-Expansion (Fixed) Expansion, 2801 lb Dynamic/1651 lb Static Load, -20 to 200 deg F, 3500 rpm Maximum, Cast Iron, Gray Painted

• Eccentric locking design incorporates a precision eccentric collar to mate with the inner ring extension for shaft hold
• The rugged base design provides an excellent mounting foundation, this is integral to prevent sheet metal "buckling"
• Positive contact molded nitrile rubber contact seal
• An anti-rotation rivet prevents outer ring creep or rotation, within the housing
• Zone hardened inner race
• Spherical outer diameter bearing insert
• 52100 steel insert
• Alemite fitting lubrication
• Nylon retainer

• Specification Sheet https://externalassets.unilogcorp.com/ASSETS/DOCUMENTS/ITEMS/EN/Browning_767291_Specification_Sheet.pdf
• Instruction/Installation Manual https://externalassets.unilogcorp.com/ASSETS/DOCUMENTS/ITEMS/EN/Browning_767404_Manual.pdf